Author Archives: Gunar Lorenz

A Lego Block Approach to MEMS Design

The Smart Systems Integration conference took place in Copenhagen on March 10-12, 2015. We were invited to join a panel discussion with the title “Towards a “Lego block principle” for heterogonous systems design including MEMS and electronics –Choose and put together-fit”. The capital of Denmark felt like the natural place to discuss a “Lego block principle” and so I happily accepted to represent Coventor in the discussion. read more…

Breakthrough MEMS Models for System and IC Designers

Gunar Lorenz, PhD
Director, System Level Simulation

We just rolled out MEMS+ 5.0 with lots of new capabilities for our users. I discussed some of the new features, support of scanning mirrors in particular, in a previous post. This time I would like to focus on the new capabilities for exporting reduced order models (ROMs) of MEMS devices that system engineers can place in their Simulink schematics and IC designers can place in their circuit schematics.

Before getting into the technical stuff, allow me to provide some motivation. To design the control and signal processing electronics that go around every MEMS device, system engineers usually work in Simulink while circuit designers work in schematic entry tools such as Cadence Virtuoso. There’s a MEMS block in their flow diagram or schematic with an underlying model that captures the coupled electromechanical behavior of the MEMS device. It’s common practice to “hand craft” the MEMS behavioral model, but hand crafted models have many shortcomings: they’re usually over simplified, capturing only one degree of freedom and omitting nonlinear effects. Furthermore, it’s difficult to keep hand crafted models in sync with evolving device designs. All of these shortcomings can be avoided by using ROMs exported from MEMS+ instead of hand-crafted models.
read more…

Sneak Peak: New Capabilities for Micro Scanning and Projection Mirrors

By Gunar Lorenz, Director, System Level Simulation

Once again we are entering the final phase of a MEMS+ release cycle. We are tying up loose endsfor for another exciting release, over the summer, of our unique MEMS design software. I believe that the results of our latest research and development efforts will impress our users. You may ask: what’s so exiting about the new release? Well, it will surely require more than one blog to tell you about the many new features. For this blog, I will focus on the new capabilities in MEMS+ 5.0 that address the special design challenges presented by micro mirrors. Even if you are not working on micro mirror applications yourself, you may have heard about the new mini-projectors for smartphones from Fraunhofer or the new industrial devices from companies like Mirrorcle Technologies, Inc., Hamamatsu or Preciseley Microtechnology Corp: read more…