Kira Egelhofer Ruegger, Author at Coventor

Filter by
Categories
Tags
Authors
Show all

All
Coventor Blog
Press Releases

All
3D DRAM
3D NAND
ALD
AVS 68
BEOL
bulk Si
Capacitance Analysis
CFET
chip packaging
CMP
Coventor
CoventorMP
CoventorWare
Defect Analysis
Deposition
Digital Twins
DRAM
dry etch
DSOI
DTCO (Design Technology Co-Optimization)
EDTM 2023
Equipment Intelligence
Etch
EUV
Extreme Ultraviolet lithography
FEOL
FinFET
gyroscope
HVM
IEEE Inertial Sensors 2023
IEEE MEMS 2023
imec
ISS 2023
Line Edge Roughness (LER)
Lithography and Patterning
Machine Learning
MEMS
MEMS Accelerometer
MEMS gyroscope
MEMS Inertial Sensors
MEMS Micro Mirror
MEMS Microphone
MEMS PDK (Process Design Kits)
MEMS Pressure Sensor
MEMS RF Switch
MEMS Seismometer
MEMS Switch
MEMS+
mesh
Meshing
Nanosheet
NEMS
NEMS BEOL
Netlist
Netlisting
Piezoelectric MEMS
Process Library
Process Model Calibration
Process Window Optimization
SADP
SAQP
SEMI
SEMICON Korea 2023
Semiconductor Metrology
SEMulator3D
SEMulator3D; DRAM; FEOL
Silicon Photonics
SOI
SPIE Advanced Lithography 2023
SRAM
TCAD
Technology Review
Technology Reviews

April 15, 2021

Figure 2. SEMulator3D meshes generated for the model shown in Fig. 1. Left: Delaunay; Center: standard; Right: simple. Cross sections are shown for the Delaunay and standard meshes but the full model is shown for the simple mesh because the volume mesh is not accessible and thus no cross-section view is possible.

Published by Kira Egelhofer Ruegger at April 15, 2021

Connecting SEMulator3D to Third-Party Design and Analysis Software Using Meshing

In the semiconductor modeling world, no simulation software can do everything. That is, each has its own strengths – process modeling, lithography analysis, and circuit design being a few examples. […]